TempSense temperature controller is an in-line controller for heating a wide array of products and systems. TempSense provides up to 350 watts continuous power. ( 3 amps.) Just plug it into a power supply, connect the appropriate thermocouple and it starts operating to a preprogrammed profile that resides in non-volatile memory.
SPECIFICATIONS
|
|
|
0 to 450 Deg F
-20 to 250 Deg C
|
With resolution to 1 degree read out.
|
|
|
|
5 to 20 Degrees
per minute
|
Selectable through software interface.
|
|
|
|
.Infinite, "continuous" operation
or selectable for a set duration
|
From 1 to 9999 minutes in 1 minute increments.
|
|
|
|
Thermocouple
Type "J" or "K"
|
Selectable through software interface or factory set
|
|
|
|
Nonvolatile
|
Controller will restart automatically after a power interruption
using the last programed as defaults
|
|
|
|
Logging rates 0 to 60
minutes
|
Programmable through interface to data log at intervals from 0 to
60 minutes in 1 second intervals. Down loaded to spreadsheet
on a PC for analysis at a later time
|
|
|
|
2.0" x 3.0" x 1.5"Customer may specify the input power cable and connector and
|
Small size allows placement in tight areas or can be piggybacked
onto existing heater systems
|
|
|
|
100-120 VAC or 200-240
VAC single phase.
|
Customer selectable at time of order.
|
|
|
|
|
Customer may specify the input power cable and connector and output cable and connector to meet customer requirements
|
|
The “TempSense” Controller works with proprietary software “TempWare Premier” that can set temperature, ramp rate, continuous or ramp and soak. The TempWare interface allows for data logging at intervals from 0 to 60 minutes. “TempWare Premier” interface allows for retrieval of resident parameters during controller operation without interruption. “TempWare Premier” interfaces with controller through a serial port and a RS485 on the TempSense Controller. A dongle is required.
